Metra ASWC Manuel d'installation télécharger pdf (Page 10)

Troubleshooting the Auto Detect Mode

So you tried the auto detect feature and at the end the led did not stay

on solid red, it started ashing. That means the ASWC did not detect the

vehicle. Follow these couple steps to determine what happened:

First some basic steps:

1) Verify that you have 12 volt accessory and a good ground to the ASWC.

2) Verify with the vehicle information sheet on the Axxess website that you

connected the correct steering wheel control wires in the vehicle to the

correct wire(s) on the ASWC.

3) Verify that the 3.5mm connector is connected to your radio securely and

in the correct location.

4) If using the female 3.5mm connector on an Eclipse or Kenwood radio,

verify that the radio’s SWC wire is connected to the correct wire on the

ASWC.

Once all the information above has been veried and correct, refer back to

the 2 sets of led ashes during the auto detect sequence. Here is what the

ashes stand for:

LED Feedback

The 1st series of led ashes represent the wire(s) that are connected to the

vehicle from the ASWC.

Short ashes represent the steering wheel control wire(s) that are not con-

nected to the vehicle from the ASWC.

Long ashes represent the wire(s) that are connected to the vehicle.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Pas de commentaire

Metra ASWC Manuel d'installation Page 10